Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 370)

370 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 12 Configuring Authentication Types
Creating and Applying EAP
Method Profiles for the
802.1X Supplicant This section describes the optional configuration of an EAP method list for the
802.1X supplicant. Configuring EAP method profiles enables the supplicant not
to acknowledge some EAP methods, even though they are available on the
supplicant. For example, if a RADIUS server supports EAP-FAST and LEAP,
under certain configurations, the server can initially employ LEAP instead of a
more secure method. If no preferred EAP method list is defined, the supplicant
supports LEAP, but it can be advantageous to force the supplicant to force a more
secure method such as EAP-FAST.
• Use the
no command to negate a command or set its defaults.
• Use the show eap registrations method command to view the currently
available (registered) EAP methods.
• Use the show eap sessions command to view existing EAP sessions.
See Creating a Credentials Profile on page 195 for additional information about
the 802.1X supplicant.
Creating an EAP Method Profile
Beginning in privileged exec mode, follow these steps to define a new EAP
profile:
1. Enter global configuration mode.
configure terminal
2. Enter a name for the profile.
eap profile profile name
3. (Optional)—Enter a description for the EAP profile.
description
4. Enter an allowed EAP method or methods.
method fast
5. Return to the privileged EXEC mode.
end
6. (Optional) Save your entries in the configuration file.
copy running config startup-config
TIP Although they appear as sub-parameters, EAP-GTC, EAP-MD5, and
EAP-MSCHAPV2 are intended as inner methods for tunneled EAP
authentication and must not be used as the primary authentication
method.