Logging into and exiting a privilege level, Controlling access point access with radius, Controlling access point access with – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 208
208
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 6
Administering the WAP Access
show running-config
or
show privilege
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config
When you set a command to a privilege level, all commands whose syntax is a
subset of that command are also set to that level. For example, if you set the
show
ip route
command to level 15, the
show
commands and
show ip
commands are automatically set to privilege level 15 unless you set them
individually to different levels.
To return to the default privilege for a given command, use the
no privilege
mode level level command
global configuration command.
This example shows how to set the
configure
command to privilege level 14
and define
SecretPswd14
as the password users must enter to use level 14
commands:
AP(config)# privilege exec level 14 configure
AP(config)# enable password level 14 SecretPswd14
Logging Into and Exiting a Privilege Level
Beginning in privileged EXEC mode, follow these steps to log in to a specified
privilege level and to exit to a specified privilege level:
1. Log in to a specified privilege level.
For
level, the range is 0…15.
enable level
2. Exit to a specified privilege level.
For
level, the range is 0…15.
disable level
Controlling Access Point
Access with RADIUS
This section describes how to control administrator access to the wireless device
by using Remote Authentication Dial-In User Service (RADIUS). For complete
instructions on configuring the wireless device to support RADIUS, see
Configuring RADIUS and TACACS+ Servers on page 407
RADIUS provides detailed accounting information and flexible administrative
control over authentication and authorization processes. RADIUS is facilitated
through AAA and can be enabled only through AAA commands.
For complete syntax and usage information for the commands used in this
chapter, see the