Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 143)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 143
Stratix 5100 Device Manager Parameter Definitions Chapter 4
Action Select Forward or Block. Click Add. The MAC address appears in the Filters Classes
field.
Default Action Packets that do not match any of the Filters Classes are handled according to the
Default Action.
Select Forward All or Block All. The filter's default action must be opposite of the
action for at least one of the addresses in the filter. For example, if you enter
several addresses and you select Block as the action for all of them, you must
choose Forward All as the filter's default action.
When you click Apply, the filter is saved on the access point, but it is not enabled
until you apply it on the Apply Filters page.
Filters Classes To remove the MAC address from the Filters Classes list, select it and click Delete
Class.
Table 49 - MAC Address Filters Page Parameter Descriptions (Continued)
Parameter Description