Using ftp to access the mib files – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 580
Advertising
580
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Appendix B
Supported MIBs
• CISCO-TC-MIB
• CISCO-SYSLOG-MIB
• CISCO-WDS-INFO-MIB
• ENTITY-MIB
• IF-MIB
• OLD-CISCO-CHASSIS-MIB
• OLD-CISCO-SYS-MIB
• OLD-CISCO-SYSTEM-MIB
• OLD-CISCO-TS-MIB
• RFC1213-MIB
• RFC1398-MIB
• SNMPv2-MIB
• SNMPv2-SMI
• SNMPv2-TC
Using FTP to Access the MIB
Files
Follow these steps to obtain each MIB file by using FTP:
1. Use FTP to access the server
ftp.cisco.com
.
2. Log in with the username: anonymous.
3. Enter your e-mail username when prompted for the password.
4. At the
ftp>
prompt, change directories to
/pub/mibs/v1 or /pub/mibs/v2.
5. Use the
get
MIB_filename
command to obtain a copy of the MIB file.
TIP
You can also access information about MIBs on the Cisco web site:
Advertising