Cli configuration example, Configuring wds-only mode – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 391
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
391
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Chapter 13
This password must match the password that you create for the access
point on your authentication server.
7. Click Apply.
The access points that you configure to interact with the WDS automatically
perform these steps:
• Discover and track the current WDS device and relay WDS
advertisements to the wireless LAN.
• Authenticate with the WDS device and establish a secure communication
channel to the WDS device.
• Register associated client devices with the WDS device.
CLI Configuration Example
This example shows the CLI commands that are equivalent to the steps listed in
the
Configuring Access Points to Use the WDS Device on page 390
AP# configure terminal
AP(config)# wlccp ap username APWestWing password 7
wes7win8
AP(config)# end
In this example, the access point is enabled to interact with the WDS device, and
it authenticates to your authentication server by using APWestWing as its
username and wes7win8 as its password. You must configure the same username
and password pair when you set up the access point as a client on your
authentication server.
For complete descriptions of the commands used in this example, see th
Configuring WDS-Only Mode
WDS access points can operate in WDS-only mode by using the
wlccp wds
mode wds-only
command. After issuing this command and reloading, the
access point starts working in the WDS-only mode.
• In WDS-only mode, the dot11 subsystems are not initialized and the
dot11 interface related commands cannot be configured.
• In WDS-only mode, the WDS supports up to 60 infrastructure access
points and up to 1200 clients. Use the
no
form of this command to turn
off WDS-only mode. Use the
show wlccp wds
command to display the
working mode of the WDS access point.