Workgroup bridge – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 27

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
27
Getting Started with the Stratix 5100 WAP
Chapter 1
Figure 3 - Access Point as a Root Bridge with Clients
Figure 4 - Access Points as Root and Non-root Bridges with Clients
Workgroup Bridge
You can configure access points as workgroup bridges. In workgroup bridge
mode, the unit associates to another access point as a client and provides a
network connection for the devices connected to its Ethernet port. For example,
if you need to provide wireless connectivity for a group of network printers, you
can connect the printers to a hub or to a switch, connect the hub or switch to the
access point Ethernet port, and configure the access point as a workgroup bridge.
The workgroup bridge associates to an access point on your network.
If your access point has multiple radios, either radio can function in workgroup
bridge mode.
Root bridge
Non-root bridge
135447
Root bridge
Non-root bridge
135446