Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 519)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 519
Configuring SNMP Chapter 19
AP(config)# snmp-server view iso iso included
AP(config)# snmp-server engineID remote 1.4.74.10
1234567890
AP(config)# snmp-server group admin v3 priv
AP(config)# snmp-server group admin v3 priv read iso
write iso
AP(config)# snmp-server user joe admin v3 auth md5
xyz123 priv des56 key007
AP(config)# snmp-server user fred admin v3 encrypted
auth md5 abc789 priv des56 key99
Displaying SNMP Status To display SNMP input and output statistics, including the number of illegal
community string entries, errors, and requested variables, use the
show snmp
privileged EXEC command.
For information about the fields in this display, see the Cisco IOS Configuration
Fundamentals Command Reference and the Cisco IOS IP and IP Routing
Command Reference
.
TIP After you enter the last command in this example, the show running-config
and show startup-config commands display only a partial SNMP configuration.