Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 589)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 589
Error and Event Messages Appendix C
Inter-Access Point Protocol
Messages
Local Authenticator
Messages
SOAP_FIPS-2-SELF_TEST_RAD_FAILURE:
“RADIO crypto FIPS self test failed at %s
on interface %s %d.”
SOAP FIPS self test on radio crypto routine failed. Check radio image.
SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: “IOS
crypto FIPS self test passed.”
SOAP FIPS self test passed. None
SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS:
“RADIO crypto FIPS self test passed on
interface %s %d.”
SOAP FIPS self test passed on a radio interface.
DOT11-6-MCAST_DISCARD: “%s mode multicast
packets are discarded in %s multicast
mode.”
The access point configured as a workgroup bridge and
drops infrastructure mode multicast packets in client
mode and drops client mode multicast packets in
infrastructure mode. None
Table 6 - Subsystem Messages (Continued)
Message Explanation Recommended Action
Message Explanation Recommended Action
DOT11-6-STANDBY_ACTIVE: “Standby to
Active, Reason = %s (%d).”
The access point is transitioning from standby mode to
active mode for the indicated reason. None.
DOT11-6-STANDBY_REQUEST: “Hot Standby
request to shutdown radios from %e.”
The indicated standby access point has requested that this
access point shut down its radio interfaces because a
failure has been detected on one of this access point’s
radio interfaces. None.
DOT11-6-ROGUE_AP: “Rogue AP %e reported.
Reason: %s.”
A station has reported a potential rogue access point for
the indicated reason. None.
Message Explanation Recommended Action
RADSRV-4-NAS_UNKNOWN: Unknown
authenticator: [ip-address]
The local RADIUS server received an authentication
request but does not recognize the IP address of the
network access server (NAS) that forwarded the request. Make sure that every access point on your
wireless LAN is configured as a NAS on your
local RADIUS server.
RADSRV-4-NAS_KEYMIS: NAS shared key
mismatch.
The local RADIUS server received an authentication
request but the message signature indicates that the
shared key text does not match. Correct the shared key configuration on
either the NAS or on the local RADIUS server.
RADSRV-4_BLOCKED: Client blocked due to
repeated failed authentications
A user failed authentication the number of times
configured to trigger a block, and the account been
disabled. Use the clear radius local-
server user username
privileged EXEC command to unblock the
user, or allow the block on the user to expire
by the configured lockout time.
DOT1X-SHIM-6-AUTH_OK: “Interface %s
authenticated [%s].”
The 802.1x authentication was successful. None
DOT1X-SHIM-3-AUTH_FAIL: “Interface %s
authentication failed.”
The 802.1x authentication failed to the attached device. Check the configuration of the 802.1x
credentials on the client as well as the
RADIUS server.
DOT1X-SHIM-3-INIT_FAIL: “Unable to init -
%s.”
An error occurred during the initialization of the shim
layer.