Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 261)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 261
Configuring Radio Settings Chapter 7
configure terminal
2. Enter the configuration interface for the 802.11a radio
interface dot11radio1 dfs
3. For number, enter one of the following channels: 36, 40, 44, 48, 149, 153,
157, 161, 5180, 5200, 5220, 5240, 5745, 5765, 5785, or 5805.
Enter dfs and one of the following frequency bands to use dynamic
frequency selection on the selected channel:
1 - 5.150…5.250 GHz
2 - 5.250…5.350 Ghz
3 - 5.470…5.725 GHz
4 - 5.725…5.825 GHz
If you attempt to configure a channel that can only be selected by dfs, the
following message appears:
This channel number/frequency can only be used by
Dynamic Frequency Selection (DFS)
channel number | dfs |band <1 - 5>}
4. Return to the privileged EXEC mode.
end
5. Verify your entries
show running-config
6. (Optional) Save your entries to the configuration file.
copy running-config startup-config
The following example selects channel 36 and configures it to use DFS on a
frequency band 1:
ap#configure terminal
ap(config)interface dot11radio1
ap(config-if) channel 36
ap(config-if)
Blocking Channels from DFS Selection
If your regulatory domain limits the channels that you can use in specific
locations--for example, indoors or outdoors, you can block groups of channels to
prevent the access point from selecting them when DFS is enabled. Use this
configuration interface command to block groups of channels from DFS
selection:
[no] dfs band [1] [2] [3] [4] block