Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 582)

582 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Appendix C Error and Event Messages
Software Auto Upgrade
Messages This table explains the messages when you are upgrading the software.
Action Flags Internal to the code for additional action to display. 0—No action flag
MSG-TRACEBACK—includes traceback with message
MSG-PROCESS—includes process information with message
MSG-CLEAR—indicates condition had cleared
MSG-SECURITY—indicates as security message
MSG-NOSCAN—suppresses EEM pattern screening
%d An integer number. 2450
%e A MAC address. 000b.fcff.b04e
%s A message string that provides more detail of the
error. “Attempt to protect port 1640 failed.”
%x A hexadecimal number. 0x001
Table 1 - Conventions for System Error Messages (Continued)
Message Component Description Example
Table 2 - Software Auto Upgrade Messages
Message Explanation Recommended Action
SW-AUTO-UPGRADE-2-FATAL_FAILURE: “Attempt to
upgrade software failed, software on flash may be
deleted. Please copy software into flash.
Auto upgrade of the software failed. Check to
see if the software has been deleted. Copy
software into the flash. Copy software before restarting the
unit.
SW-AUTO-UPGRADE-7-DHCP_CLIENT_FAILURE: “%s”: Auto
upgrade of the software failed.”
Auto upgrade of the software failed. Make sure that the DHCP client is
running.
SW-AUTO-UPGRADE-7-DHCP_SERVER_FAILURE: “%s”: Auto
upgrade of the software failed.”
Auto upgrade of the software failed. Make sure that the DHCP server is
configured correctly.
SW-AUTO-UPGRADE-7_BOOT_FAILURE: “%s”: Auto upgrade
of the software failed.”
Auto upgrade of the software failed. Restart the unit. If the message appears
again, copy the error message exactly
as it appears and report it to your
technical support representative.
AUTO-INSTALL-4-STATION_ROLE: “%s”: The radio is
operating in automatic install mode.”
The radio is operating in automatic install
mode. Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
AUTO-INSTALL-4-IP_ADDRESS_DHCP: “The radio is
operating in automatic install mode and has set ip
address dhcp.”
The radio is operating in automatic install
mode and is configured to receive an IP
address through DHCP. Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
Error Message: AUTO-INSTALL-6_STATUS:
“%s” %s. RSSI=-%d dBm.: “The radio is
operating in install mode.”
The radio is operating in automatic install
mode. Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
AVR_IMAGE_UPDATE-7-UPDATE_COMPLETE: “The AVR "$d"
firmware was successfully updated.”
The access point AVR firmware was
successfully updated. No action is required.
AVR_IMAGE_UPDATE-2-UPDATE_FAILURE: “The AVR "$d"
firmware is not current. Update error: "$s".”
The AVR firmware is not current and the
update failed Copy the error message and report it to
your technical support representative.
AVR_IMAGE_UPDATE-4-UPDATE_SKIPPED: “AVR "$d" update
processing was skipped:"$s".”
AVR update processing was skipped due to an
error. No action is required.
AVR_IMAGE_UPDATE-4-UPDATE_START: “The system is
updating the AVR "$d" firmware. Please wait . . . “
The system is updating the AVR firmware. No action is required.