Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 275)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 275
Configuring Radio Settings Chapter 7
4. Set the maximum RTS retries. Enter a setting from 1…128.
rts retries value
5. Return to privileged EXEC mode.
end
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config
Use the no form of the command to reset the RTS settings to defaults.
Configuring the Maximum
Data Retries The maximum data retries setting determines the number of attempts the
wireless access point makes to send a packet before giving up and dropping the
packet.
The default setting is 32. Beginning in privileged EXEC mode, follow these steps
to configure the maximum data retries:
1. Enter global configuration mode.
configure terminal
2. Enter interface configuration mode for the radio interface.
• The 2.4 GHz radio and the 2.4 GHz 802.11n radio is 0.
• The 5 GHz radio and the 5 GHz 802.11n radio is 1.
interface dot11radio {0 | 1}
3. Set the maximum data retries. Enter a setting from 1…128.
packet retries value
4. Return to privileged EXEC mode.
end
5. (Optional) Save your entries in the configuration file.
copy running-config startup-config
Use the no form of the command to reset the setting to defaults.
Configuring the
Fragmentation Threshold The fragmentation threshold determines the size that packets are fragmented
(sent as several pieces instead of as one block). Use a low setting in areas where
communication is poor or where there is a great deal of radio interference.
The default setting is 2338 bytes. Beginning in privileged EXEC mode, follow
these steps to configure the fragmentation threshold:
1. Enter global configuration mode.
configure terminal
2. Enter interface configuration mode for the radio interface.