Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 50)

50 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 2 Install the Stratix 5100 Wireless Access Point/Workgroup Bridge
Configure the Access Point The configuration process takes place on the WAP using the Stratix 5100 Device
Manager. For instructions on how to configure the Wireless Access Point/
Workgroup Bridge by using Straitx 5100 Device Manager software, see
Stratix
5100 Device Manager Configuration Startup on page 51 .
TIP Remember that you must do the initial configuration using CLI and the console
cable. See
Connect to the Stratix 5100 WAP Access Point Locally on page 54
and Configure the Stratix 5100 WAP Using the Command-Line Interface on
page 175 for detailed information.