Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 451)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 451
Configuring VLANs Chapter 15
In this scenario, a minimum of three VLAN connections are required, one for
each level of access. Because the access point can handle up to 16 SSIDs, you can
use the basic design shown in this table.
Managers configure their wireless client adapters to use SSID boss, faculty
members configure their clients to use SSID teach, and students configure their
wireless client adapters to use SSID learn. When these clients associate to the
access point, they automatically belong to the correct VLAN.
Complete these steps to support the VLANs in this example:
1. Configure or confirm the configuration of these VLANs on one of the
switches on your LAN.
2. On the access point, assign an SSID to each VLAN.
3. Assign authentication types to each SSID.
4. Configure VLAN 1, the Management VLAN, on both the fastEthernet
and dot11radio interfaces on the access point. Make this VLAN the native
VLAN.
5. Configure VLANs 2 and 3 on both the fastEthernet and dot11radio
interfaces on the access point.
6. Configure the client devices.
Table 104 - Access Level SSID and VLAN Assignment
Level of Access SSID VLAN ID
Management boss 01
Faculty teach 02
Student learn 03