Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 546)

546 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 20 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
Enabling VideoStream
Support on Workgroup
Bridges VideoStream improves the reliability of an IP multicast stream by converting the
multicast frame, over the air, to a unicast frame. Cisco IOS Releases 15.2(2)JA
and later provide VideoStream support for wired devices connected to
workgroup bridges.
For access points running release 15.2(2)JA and later, the workgroup bridge is
added to the wireless LAN controller (WLC) multicast table, and the workgroup
bridge converts the VideoStream unicast frame into an Ethernet multicast frame
and sends it out to its wired clients.
Enter this command on the WLC to enable VideoStream for workgroup bridges:
config media-stream wired-client enable