Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 591)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 591
Error and Event Messages Appendix C
Mini IOS Messages
Access Point/Bridge
Messages
Cisco Discovery Protocol
Messages
External Radius Server Error
Messages
Message Explanation Recommended Action
MTS-2-PROTECT_PORT_FAILURE: An attempt to
protect port [number] failed
Initialization failed on attempting to protect port. None.
MTS-2-SET_PW_FAILURE: Error %d enabling
secret password.
Initialization failed when the user attempted to enable a
secret password. None
Saving this config to nvram may corrupt
any network management or security files
stored at the end of nvram. Continue?
[no]:
This warning message appears on the access point CLI
interface while saving configuration changes through CLI.
This is due to insufficient space in flash memory. When a
radio crashes, .rcore files are created. These files indicate a
firmware or a hardware problem in the radio, although a
hardware problem is less likely. This warning message can be prohibited by
removing the rcore files generated in flash
memory. The rcore files have a .rcore
extension. The files can be deleted because
they simply show that the radio went down
at some point. The .rcore files can be listed on
CLI session and appear similar to this:
r15_5705_AB50_A8341F30.rcore
Message Explanation Recommended Action
APBR-4-SEND_PCKT_FAILED: Failed to Send
Packet on port ifDescr (error=
errornum)errornum: status error number
HASH(0x2096974) The access point or bridge failed to send a
packet. This condition can be seen if there is
external noise or interference.
Check for sources of noise or
interference.
APBR-6-DDP_CLNT_RESET: Detected probable reset of
hosthost: host MAC address HASH(0x2080f04) The access point or bridge detects that
another infrastructre device has restarted.
If this message appears continuously,
reboot the access point.
Message Explanation Recommended Action
CDP_PD-2-POWER_LOW: %s - %s %s (%e) The system is not supplied with sufficient power. Reconfigure or replace the source of inline
power.
Message Explanation Recommended Action
RADUYS:response-authenticator decrypt
fail, paklen 32
This error message means that there is a mismatch in the
RADIUS shared key between the RADIUS server and the
access point. Make sure that the shared key used on the
RADIUS server and the access point are the
same.