Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 277)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 277
Configuring Radio Settings Chapter 7
Performing a Carrier Busy
Test You can perform a carrier busy test to check the radio activity on wireless
channels. During the carrier busy test, the wireless access point drops all
associations with wireless networking devices for 4 seconds while it conducts the
carrier test and then the test results appear.
In privileged EXEC mode, enter this command to perform a carrier busy test:
dot11 interface-number carrier busy
For interface-number, enter dot11radio 0 to run the test on the 2.4 GHz
radio, or enter dot11radio 1 to run the test on the 5 GHz radio.
Use the show dot11 carrier busy command to show the carrier busy test
results.
Configuring ClientLink Cisco ClientLink (referred to as Beam Forming) is an intelligent beamforming
technology that directs the RF signal to 802.11a/g devices to improve
performance by 65%, improve coverage by up to 27% percent, and reduce
coverage holes.
Cisco ClientLink helps extend the useful life of existing 802.11a/g devices in
mixed-client networks. It is beneficial for organizations that move to 802.11n
and want to make sure that all clients on the network, regardless of type, are
guaranteed the bandwidth and throughput they need.
Using CLI to Configure ClientLink
To enable ClientLink, enter this CLI command in interface configuration mode
on 802.11n radio interfaces:
beamform ofdm
The ClientLink configuration option is not available through GUI.
ClientLink is disabled by default. Additional details can be found on cisco.com at
http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps10092/
white_paper_c11-516389.html