Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 325)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 325
Configure an Access Point as a Local Authenticator Chapter 10
9. From Default Server Priorities, determine the level of priority you want to
assign to each server.
10. Select Priority 1, 2, or 3 for this server.
11. Click Apply to add the server.
Steps step 12 through step 16 are optional tasks and can be skipped to
expedite setup.
12. Click the Global Properties tab.
13. In the Accounting Updates Interval field, specify the interval that you
want the accounting updates to be performed.
14. In the TACACS+ Server Timeout field, specify the number of seconds an
access point waits for a reply to a TACACS+ request before resending the
request.
15. In the RADIUS Server Timeout field, specify the number of seconds an
access point waits for a reply to a RADIUS request before resending the
request.
16. In the RADIUS Server Retransmit Retries field, specify the number of
times the access point sends each RADIUS request to the server before
giving up.
If more than one RADIUS server is configured for MAC authentication,
enable the Dead Server List option.
a. Specify how long you want the unresponsive RADIUS servers to be
skipped over when the access point is attempting RADIUS server
authentication.
b. Enter this amount in the Server remains on list for text field.
17. Click Apply.