Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 157)

Operator Interface 3-35
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
You will access the "SETUP" screen from the Top Level Menu by
pressing the [F8] key. This
will result in the typical screen shown in
Figure 3.39 .
The Current Access level is shown. If it states 'Monitor' then you are
restricted to only viewing the basic drive setup. You cannot make
any changes. You must be in at least the 'Basic' access level in order
to modify any of the drive parameters, and you may only modify the
parameters for which you can view at the given access level.
At power-up , the operator interface access level is 'Monitor'. If this
is the current mode and you wish to change any of the setup data,
press the [F8] key now in order to change the access level before
proceeding into any of the other setup operations available from this
screen
(Figure 3.40) . Refer to the section Enter/Modify an Access
Level .
Figure 3.39 – Setup Screen
Figure 3.40 – Basic Access Level