Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 174)

3-52 Operator Interface
7000L-UM300I-EN-P – June 2013 7000 “C” Frame
Figure 3.69 – Bit Encoded Parameter
Figure 3.70 – Bit Description for Local Outputs
The DISPLAY screen, typical of Figure 3.68, is displayed. The
screen shows the name of the group being displayed to the right of
the screen name (“FEATURE SELECT”).
P Nameplate). One or
more pages of the members in the group are displayed along with the
value for this tag in the drive and its unit of measurement. Values
that are bit encoded
will show a hex value for the parameter value.
Use the up/down cursor keys to select the parameter which is bit
encoded and then press the [enter] key
(Figures 3.69 and 3.70) . The
VIEW PARAMETER screen will then show that parameter as it is
decoded per bit as shown in
Figure 3.70.
The left side of the pair shows the name of the bit, while the right
side shows the current value of the bit within the parameter.
All of these values are updated from the drive on a continual basis.
From the DISPLAY screen, it is possible to modify a parameter. If
the group you are currently viewing contains parameters, press the
[F7] key. The operator interface then allows you to select the
parameter you wish to modify. Refer to the section entitled "Modify
Parameters" for further details.