Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 175)

Operator Interface 3-53
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
If you have modified any parameters in the drive, you will be
prompted to make the changes permanent. This prompt will occur
upon exiting the DISPLAY GROUP screen. Refer to "Message
Prompting" for further details.
Custom Group
From the DISPLAY GROUP screen (Figure 3.67) you can select a
group which you have custom defined by pressing the [F7] key.
This custom group contains selected tags from one or more other
groups, arranged by you onto a single screen for more convenient
viewing (Figure 3.71).
To assign a tag to the display, use the [cursor up] and [cursor down]
keys to highlight the desired item position and press the [enter] key.
This will begin the selection process of a tag as described in the
section entitled "Select a Parameter ". When you have completed
the selection process, the selected tag will be assigned to the item, as
in Figure 3.72. To remove a tag from the highlighted item, press the
[delete] (Backspace) key.
Figure 3.71 – Display Custom Screen
Figure 3.72 – V Line Assigned
The changes take affect immediately, however are not saved until
you press [F10] and exit the screen. Any time prior to this you may
cancel all the changes made after coming to the screen by pressing
the [F7] key.