Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 197)

Operator Interface 3-75
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
Pressing the [F7] key changes the format of the displayed data. When
data is shown as a mixture, a particular value is displayed based on the
priority defined above, (control characters is highest).
The RX row displays data received by the operator interface. The
TX row displays the data transmitted by the operator interface.
Print Screen
The print screen operation allows a screen dump of the operator
interface's display. This requires the use of a second RS232 port
communicating at 9600 Baud to an external computer. Special
software is required in the computer to receive the data and to
interpret the data.
The operation is initiated from any screen by pressing the [F10] key
and the [cursor right] key at the same time. The screen will clear
and a message will indicate that the screen is being printed as well as
the percentage completed. When complete, the original screen will
return.
Memory Dump
The memory dump allows any directly accessible memory (i.e.
memory which is directly addressable and does not require access
through a port) to be monitored. It is called from any screen (except
the PRINTER screen), by pressing the [F10] key and the [cursor left]
key at the same time.
Figure 3.101 – Data Segment Memory Dump
The initial screen, (Figure 3.101) shows the data segment by default.
Each screen shows the segment (in hex) which is being viewed. In
the left column is the starting address (in hex) for the row of data.
Eight bytes of data are shown in Hex, followed by the equivalent 8
ASCII characters (if relevant). Additional data within the segment is
viewed by pressing the [F8] and [F9] keys.