Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control User Manual
Page 171
Operator Interface 3-49
7000 “C” Frame
7000L-UM300I-EN-P – June 2013
Figure 3.62 – Message Prompt Screen
Figure 3.63 – NVRAM Screen
Store/Retrieve Configuration (NVRAM)
To access the memory functions, press [F5] on the Top Level Menu.
Within this screen it is possible to perform three operations on the
memory of the drive. To perform these operations you must have
the proper access to the drive. Refer to the section entitled
Enter/Modify an Access Level
.
Initialize
The drive contains a default set of parameters and setup information.
This can form a basis for configuring the drive. To initialize the
drive with the default set of data, press the [F3] key. The screen will
appear as in Figure 3.64, indicating the operation you are about to
perform.
The screen then will ask you to confirm the operation. Press the
[F8] key to proceed, or the [F9] key to abort. Performing an
initialization will overwrite the data currently in the drive. Previous
changes that were saved to NVRAM will not be affected.