Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control - Manual (Page 37)

Chapter
2
7000 “C” Frame 7000L-UM300I-EN-P – June 2013
Drive Installation
Safety and Codes
A T T E N T I O N A T T E N T I O N The Canadian Electrical Code (CEC), National
Electrical Code (NEC), or local codes outline
provisions for safely installing electrical
equipment. Installation MUST comply with
specifications regarding wire type, conductor
sizes, branch circuit protection and disconnect
devices. Failure to do so may result in personal
injury and/or equipment damage.
Unpacking and Inspection
Before leaving the factory, all drives have been tested both
mechanically and electrically. Immediately upon receiving the drive,
remove the packing and check for possible shipping damage. Report
any damage immediately to the claims office of the common carrier.
After unpacking the material, check the item(s) received against the
bill of lading to assure that the nameplate description of each item
agrees with the material ordered. Inspect the PowerFlex 7000 “C”
Frame drive for physical damage, as stated in the Rockwell
Automation Conditions of Sale.
I M P O R T A N T I M P O R T A N T All claims for breakage and damage whether
concealed or obvious must be made to the
carrier by the Customer as soon as possible
after receipt of the shipment. Rockwell
Automation will be glad to render the
Customer reasonable assistance in the
securing of adjustment for such damage
claims.
Remove all packing material, wedges, or braces from within the
drive. Operate the contactors and relays manually to assure that they
operate freely. If any part of the equipment will not be installed
when it is unpacked, it should be stored in a clean, dry place. The
storage temperature must be between -40°C (-40°F) and 70°C
(185°F) with a maximum humidity of 95%, non-condensing, to
guard against damage to temperature sensitive components in the
controller.