Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C Frame) - Classic Control User Manual

Page 214

Advertising
background image

Commissioning 4-9

7000 “C” Frame

7000L-UM300I-EN-P – Juen 2013


Technical Publications

Each drive is shipped with a service binder containing all technical
publications required to commission and troubleshoot the drive line-
up. This section describes how to determine what technical
publications are required and how to obtain them in the event that the
service binder is not available at the time of commissioning or
additional information is required.


PowerFlex “C” Frame Manual

The PowerFlex “C” Frame drive manual will be required during
drive commissioning to guide you through each commissioning
procedure. Copies of the manual or new revisions of the manual can
be requested from your local Rockwell Automation Office.


PowerFlex “C” Frame Parameters

The PowerFlex 7000 Technical Data publication for Parameters is

also required for Commissioning and Troubleshooting. Refer to
7000-TD001_-EN-P for the latest firmware revision.


Additional Manuals

Any additional manual required to configure the drive line-up can be
identified on the Electrical Schematics. The Schematic titled
“General Notes” identifies all required Rockwell Automation
Publications by publication number.


Resources Required to Complete

Prior to attempting to commission the drive ensure you have the

Drive Commissioning

following:

• Self powered gate driver board power supply cable (supplied

with SCR rectifier drives only)

• Rockwell Automation electrical and mechanical diagrams

• PLC program (if supplied with a PLC)

• Commissioning data sheets

• All required manuals


If any of the above information is not available prior to the time of
commissioning, please contact the factory.

Advertising