Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 103)

Chapter 7
Installing 1771 I/O
7-15
Figure 7.9
Wiring Arms Installed
Locking tab holds
wiring arm when
in position
17797
Connect I/O Lines
Use a flat-head screwdriver to remove the terminal cover from each wiring
arm to expose the terminals (if a terminal requires shielded-cable
connection, see page
7-17 ). Connect the wires between the I/O devices
and the wiring arm terminals.
Trim the length of the wire to approximately 3/4 of an inch above
its terminal.
Strip approximately 3/8 of an inch insulation from the end of the wire.
Bend the end of the wire to the right, and place the bare copper wire
under the pressure plate of the terminal screw (optionally, you can use a
spade lug).
Tighten the screw, and check that the wire is firmly in place.