Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 126)

Chapter 10
Connecting ac Power
10-3
Connect ac Line Voltage
You connect the power supply to ac line voltage. The input ranges for the
power supply are:
85 to 132V ac for 115V ac
170 to 264V ac for 220V ac
47 to 63 Hz
To connect ac power to the power supply, follow the steps below:
Important: If you are grounding the ground wire to the chassis, do not
connect the top wire.
EQPT/GND
L1
L2/N
19791
1. Wire the Line Voltage connector as shown.
2. Plug the connector into the female
connector labeled EQPT/GND L2/N L1.
3. Connect the other end of the cable to AC
power as shown in the wiring
documentation from your system designer.
To wire ac power to the industrial disk, follow the steps below:
1. If you have not already done so, wire the terminal block for ac power
as shown in chapter 5 of this manual.
ATTENTION: Make sure the ac selector switch is set to the
appropriate voltage. Otherwise you may damage
the equipment.
2. Attach the other end of the wires to ac power as shown in your
system design wiring diagram.
Industrial Disk