Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 77)

Chapter 5
Installing the Peripherals
5-6
Reattach the Front Panel
You can now re-attach the front panel of the disk as shown below.
Place the panel over the
front of the chassis and
tighten the thumbscrews.
16762
Connect the MicroVAX Information Processors
Connect the disk to the MicroVAX Information Processor as shown in
Figure 5.3 or
Figure 5.4. Connect either a one meter cable (5710-SDC) or
a two meter cable (5710-SSA).
Figure 5.3
Connecting a 159Mbyte Industrial Disk
Industrial disk (5730ĆID3)
1. Attach the one end of the cable (5730ĆIDC) to the port
labeled DISK BUS IN on the disk.
2. Attach the other end of the cable to the port labeled
HARD DISK on the MicroVAX Information Processor.
MicroVAX Information Processor
16763