Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 24)

Chapter 2
Mounting the Components
2-2
Gather these tools and supplies you will need:
#10-32 screws, lock washers, flat washers and screw driver set, if you
are rack mounting
#10-32 screws, lock washers, flat washers, and drill and tapping
equipment if you are panel mounting
wrench set, if applicable
wire brush
tape measure
marker or grease pencil
copper ground bus
two spacers, for use between the ground bus and panel
To: Then:
Panel mount the components go to page 2Ć5 .
Rack mount the components continue reading.
After you have gathered the equipment, mounting documentation, and
tools, you are ready to mount the components.
Follow these steps to rack mount the components.
1. Prepare each component.
For the 4- and 8-slot chassis, remove the brackets from the back of
the chassis, and install them on the front of the chassis for
rack mounting.
If you are using fan assembly, attach the fan assembly to the bottom
of the chassis and then mount the chassis to the rack or panel.
Remove brackets
Install brackets
19778
Gather the Tools and Supplies
Rack Mount the Components