Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 61)

Chapter 4
Installing the Modules
4-23
Connect Ethernet
To connect the processor to Ethernet, follow these steps:
16755
MicroVAX Information Processor MicroVAX processor EE or EP
1. Run the Ethernet cable to the processor as indicated
in your system designer wiring diagrams.
2. Locate the port on the processor labeled ENET CH #
(for MicroVAX Information Processor EE or EP) or
ENET CH A (for MicroVAX Information Processor)
and attach the Ethernet cable to the port.
3. Secure the connector.
ATTENTION: The Ethernet connection must be secure while
the PI system is controlling equipment; otherwise, the
MicroVAX Information Processor may shut down the system’s
power supply.
If the system power shuts down, follow these steps:
1. Make sure the Ethernet connection is secure.
2. Cycle power by turning off the power from the power supply and
turning it on again.
Make Connections to the Processor
To make the following connections to the processor, see chapter 5.
the 4-port distribution panel
the program loader
an industrial disk