Remove the front panel, Set the operating voltage and scsi address – Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL User Manual
Page 74
Chapter 5
Installing the Peripherals
5-3
Remove the Front Panel
To set the operating voltage and wire the disk you have to access the inside
of the industrial disk’s chassis. To access the inside of the industrial disk’s
chassis, remove the front panel as shown below.
Industrial disk Unscrew the four
captive screws
and remove the
front panel.
16758
Set the Operating Voltage and SCSI Address
The operating voltage is factory set to 230V ac and can be changed to
115V ac.
To set the:
On:
See:
operating voltage
5730ĆID3, 5710ĆID6, 1-ID7
Figure 5.1
operating voltage and address
5710ĆID4, ĆID5
Figure 5.1
Set Operating Voltage on a 159Mbyte Industrial Disk
1. Locate the operating voltage switch.
2. Set the switch to the operating voltage of your
system (the switch is shipped set to 230V ac and
can be changed to 115V ac).
16759