Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 164)

Installing and Removing a Module
Appendix A
A-8
To remove a module from the chassis, follow the steps below.
1. Turn off the power supply.
Turn off the
power supply.
19792
2. Remove the module from the chassis.
a. Loosen the captive thumbscrews (pull the
thumbscrews toward you to make sure they
are not screwed into the chassis).
b. Pull the ejecting tabs toward you.
c. Slide the module out of the chassis.
Ejecting tabs
19796
3. If you are replacing a module, insert the new module into the chassis.
If you are not replacing the module, install a filler plate. See
page
A-10 .
Removing a PI Module from
the Chassis