Vision processor modules, 4ć20 – Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL User Manual
Page 58
Advertising
Chapter 4
Installing the Modules
4-20
To install the CVIM module, CVIM2 module and Color CVIM module,
use Worksheet 2.2 as a guide and complete the following:
set the switch for camera power
install the vision processor module in the chassis
set the module address
make connections to the module
Set Switch for Camera Power
Before you install the module, set the switch for camera power. It is
factory set for +/– 12 volts. If you are using an external power supply for
the camera, set the switch to +24 volts as shown below.
Back of a CVIM module
±
12 factory setting
If using external power
supply for camera, put
switch in +24 position.
17087
+24
±
12
Install the CVIM Module
See appendix A to install the module in the chassis.
Vision Processor Modules
Advertising