Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 66)

Chapter 4
Installing the Modules
4-28
Set the OSI Interface Module Pushwheel Address
Follow the steps below to set the OSI interface module’s pushwheel
address. If you have more than one OSI interface module in the same
chassis, set the pushwheels sequentially; make sure you set the first OSI
interface module’s pushwheel to 1.
1
1. Locate the pushwheel on the front panel of the
carrierband or broadband Interface modules
2. Set the pushwheel as indicated on the worksheet.
Setting the pushwheel:
To: Push the:
decrease the number
increase the number
top button
bottom button
18385
Connect the OSI Interface Module
The table below lists what you can connect to the OSI interface module.
You can connect the module to: Using connector/port:
AĆB MAP Station Manager
(communicates locally as well as through the network)
carrierband or broadband
PLCĆ3  controller
PI system
ThirdĆparty device
Check the worksheet to see which connections to make. To connect to a
programming terminal running A-B MAP Station Manager software, see
chapter 5. To connect an RS-232 device, follow the steps below and see
Figure 4.2.