Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 56)

Chapter 4
Installing the Modules
4-18
To install the LP, use the worksheet as a guide and complete the following:
install the LP
install the battery
set the LP module address
make connections to the module
Install the LP
See appendix A to install the module in the chassis.
Install the Battery
To install the LP battery, see “Install the Battery” section on page 4-11
for instructions.
Set the LP Address
Follow the steps below to set the LP module address. The address must
start at 1 for the first LP and be consecutive for the other LP modules up
to 4.
1
1. Locate the pushwheel on the front panel of the LP.
2. Set the pushwheel as indicated on the worksheet.
Setting the pushwheel:
To: Push the:
decrease the number
increase the number
top button
bottom button
LP
16751
LP Module