Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 47)

Chapter 4
Installing the Modules
4-9
Follow the steps below to set the jumpers and switches.
Set Switch Bank
1. Set switch bank 1 as shown on the worksheet for the RM/KA module.
SB1
Switch bank 1 (communication channel)
(Front)
17078
Top of RM/KA module
SB1
Up (away from board)
Down (toward board)
1 2 3 4 5 6 7 8
2. Set switch bank 2 as shown on the worksheet for the RM/KA module.
SB2
Top of RM/KA module
(Front)
Switch bank 2 (station address)
17079
Up (away from board)
Down (toward board)
1 2 3 4 5 6 7 8
SB2