Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 72)

Chapter 5
5-1
Installing the Peripherals
This chapter describes how to install the following peripherals:
programming terminal
209, 418, or 480 Mbyte industrial disk (5710-ID4, -ID5, -ID6, -ID7)
159Mbyte industrial disk (5730-ID3)
4-port distribution panel (5710-DPI)
program loader (5710-PL/B)
The table below lists the page numbers for installation procedures.
To complete installation of: See page:
programming terminal 5Ć1
industrial disk 5Ć2
4Ćport distribution panel 5Ć9
program loader 5Ć9
If you are installing an industrial disk and/or a distribution panel, make
sure you have mounted and grounded these components as shown in
chapters 2 and 3.
Important: Save the packing material in case you have to ship a disk.
If you are connecting a programming terminal to the RM, follow
these steps.
1. Install a DH+ Interface Board (cat. nos. 1784-KT,-KTK1) in the
programming terminal.
2. Use the appropriate interconnect cable to connect the interface board
to the terminal as shown below. For more information on
interconnect cables, see appendix C.
Chapter Objectives
Where to Begin
Install a Programming
Terminal