Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 35)

Chapter 3
3-1
Grounding the Components
Read this chapter to learn how to ground the components.
To ground the components, complete the following:
gather the grounding documentation from your system designer
gather the necessary tools and supplies
ground the components
Gather and check the grounding documentation to locate the point of each
component that you are to ground.
Important: The 4- and 8-slot chassis have a grounding stud located on the
top left front of each chassis. Use the grounding stud to ground the chassis.
Gather the following tools you will use to ground the chassis and camera:
8 AWG stranded wire or equivalent tinned braided cable (the exact wire
should be indicated on the grounding documentation from your
system designer)
screw driver set
a wire cutter/stripper
a quantity of #10-32 screws and ring terminals
Chapter Objectives
To Ground the Components
Gather the Grounding
Documentation
Gather the Necessary Tools
and Supplies