Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 62)

Chapter 4
Installing the Modules
4-24
Replace a MicroVAX Information Processor
If you have a RM with firmware revision A04 or less and you are replacing
a 5730-CPU1 processor with either a MicroVAX Information Processor EE
or EP, or an EI module, follow the steps below.
1. Save the program image with the original module installed.
2. Power the system down.
3. Remove the module you are replacing.
4. Restore power.
5. Clear memory using 6200 series software.
6. Power the system down.
7. Install the new processor.
8. Restore power.
9. Restore the saved image to the PI system.
Important: If you have a RM with firmware revision A04 or earlier and
you’re replacing a 5730-CPU1 processor with an EI module, go to the
above section “Replace a MicroVAX Information Processor.”
To install the EI module, complete the following:
install the EI module in the chassis
connect Ethernet and make other connections to the module
check jumper settings
replace the module (if applicable)
Install the EI Module
See appendix A to install the module in the chassis.
EI Module