Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 157)

Appendix
A
A-1
Installing and Removing a Module
This appendix shows you how to:
change a memory module
install a PI module in the chassis
remove a PI module from the chassis
install filler plates
wire the connectors that come with some of the modules
The following modules have a memory module:
RM
RS2
LP
If you are changing a memory module, do so in a static safe environment
and follow the procedure below.
ATTENTION: If you perform operations on a module
improperly, you may cause an electrostatic discharge, which can
damage the module. Perform internal operations, such as
installing the memory module, only in a static safe environment.
As a minimum, we recommend the 3M Type 8005 Portable
Field Service Grounding Kit or its equivalent for providing a
static-safe environment.
Important: Turn the power supply off before removing module from the
chassis. Otherwise, you might destroy the memory.
Newer revisions of the RM, RS2 and LP have their memory module
attached with screws. Before you replace memory module, remove the
screws and detach the ribbon cable connector, then replace the
memory module.
What's in this Appendix
Changing a Memory Module