6 - installing the vision components, Chapter objectives, Installing the vision system – Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL User Manual
Page 82: Before you begin, Installing the vision components
Advertising
Chapter
6
6-1
Installing the Vision Components
This chapter shows you how to install your vision components. If you are
not installing a vision system, go to the next chapter.
To complete the installation of your vision components, you connect the:
I/O interface box
user interface box
camera to the CVIM module
I/O
board
CVIM module to a remote I/O link (optional)
Make sure you have mounted and grounded the following components as
shown in chapters 3 and 4:
monitor
(2801-N6,-N8,-N9,-N20)
I/O board (1771-JMB)
I/O interface box (2801-N21)
user interface box (2801-N22)
Chapter Objectives
Installing the Vision System
Before You Begin
Advertising