Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 155)

Chapter 12
Configuring Hardware for the MicroVAX
Information Processors
12-17
To discontinue the formatting procedure, enter: 0
You will see this message:
PV_SCS_FMTex
>>>
You will have to initiate the formatting procedure again if you wish
to format the disk.
After you have determined that the MicroVAX Information Processor
hardware is working correctly and the disk(s) you are using are formatted,
you will set two system defaults:
default boot device
default recovery mode
Set Default Boot Device
The default boot device holds the VMS software that the MicroVAX
Information Processor uses.
If you are using: To use this device as the default: Set default device to:
MicroVAX Information
Processor (cat no
disk 0 (in port) DUA0
Processor (cat. no.
5730ĆCPU1)
disk 1 (out port) DUA1
5730ĆCPU1)
remote disk on the network (if MicroVAX
is booting off a cluster)
ESA0
program loader tape drive MUA0
MicroVAX Information
Processor EP or EE
disk 0 DKA0
Processor EP or EE
(cat. no. 5731ĆCPU1,
disk 1 DKA100
(cat. no. 5731ĆCPU1,
ĆCPU2) remote disk on the network (if MicroVAX
Processor is booting off a cluster)
ESA0
program loader tape drive MKB100
To set the default boot device:
1. Make sure you are at the console prompt, then enter: TEST 51
2. When you see:
. . . . ? >>>
type the name of the boot device and press [ENTER] . For example:
DKA0 [ENTER]
Set Hardware Defaults