Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 127)

Chapter 10
Connecting ac Power
10-4
You connect the fan assembly to ac power. The input ranges for the fan
assembly are:
85 to 132Vac for 110/120V ac
170 to 264Vac for 220V ac
47 to 63 Hz
To connect the fan assembly to ac power, follow the steps below.
1. Use a 1/8" (3.1mm) wide blade, insulated handled
screwdriver to set the voltage switch to the
operating voltage of your system (it is shipped set
to 200V ac and can be changed to 100/120V ac).
2. Wire the line voltage
connector as shown.
3. Attach the wired connector to the female
connector labeled GND L2/N L1 on the
fan chassis.
4. Attach the other end of the wires to ac power
as shown in your system designer
wiring diagrams.
EQPT/GND
L1
L2/N
16797
100/120 AC 200V AC
Install each power supply for each I/O chassis as described in the
publication shipped with each power supply.
Fan Assembly
Connecting I/O Power Supplies