Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 65)

Chapter 4
Installing the Modules
4-27
Follow these steps to set the switches.
Important: Set the switches before you put the module in the chassis and
power up.
Set Switch Bank
1. Set switch 1 as shown on the worksheet.
Switch 1 (operating modes)
Top of OSI Interface module
(Front)
18414
Up (away from board)
Down (toward board)
1 2 3 4
2. Set switch 2 as shown on the worksheet.
Switch 2 (use defaults)
Top of OSI Interface module
(Front)
18415
Up (away from board)
Down (toward board)
1 2 3 4
Important: Leave switches 3 and 4 in the up position.
Install the OSI Interface Module
Install the module as shown in appendix A.
Install the Battery
To install the OSI interface module battery, see page 4-11 .