Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 57)

Chapter 4
Installing the Modules
4-19
Connect Processor Input Interrupts
Check the worksheet to see if you have to make this connection. If you do
not have to make this connection, go to the next section. If you have to
make this connection, use:
14-28 AWG wire
strip .276” (7mm) insulation from the wire
Follow the steps belows to connect the Processor Input Interrupts.
LP
1. Remove the connector on the port labeled
PROCESSOR INPUT INTERRUPTS and wire it
as shown on the worksheet.
2. Plug the wired connector into the port labeled
PROCESSOR INPUT INTERRUPTS.
3. Connect the other end of the wire as shown in
the worksheet or the wiring diagrams from your
system designer.
16752