Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 78)

Chapter 5
Installing the Peripherals
5-7
Figure 5.4
Connecting a 209Mbyte, 418Mbyte or a 480Mbyte Industrial Disk
1. Attach the one end of the cable to the port labeled DISK BUS IN
on the first disk.
2. Attach the other end of the cable to the port labeled SCSI PORT
on the MicroVAX Information Processor EE or EP.
3. If you are only connecting one disk, a terminator (5710ĆSSC)
must be placed in the port labeled DISK BUS OUT.
Terminator
MicroVAX
Information
Processor EE
or EP
18535
Industrial disk (5710-ID4, ĆID5, ĆID6, ĆID7)
Connect Second Disk
Check your documentation to see if you are to connect a second disk.
If you are: Then:
Connecting a second disk follow the steps below.
Not connecting a second disk go to the next appropriate section.
Connect either a one meter cable (5710-SDC) or a two meter
cable (5710-SSA).