Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 139)

Chapter 12
12-1
Configuring Hardware for the MicroVAX
Information Processors
This chapter shows you how to start up and test the MicroVAX
Information Processor hardware and set hardware defaults. To configure
the hardware, you must complete the following tasks:
start up and test the hardware
format the industrial disk
set hardware defaults
You need the:
MicroVAX Information Processor
terminal or workstation (VT220, VT240 or compatible, VT320, VT340
or compatible)
program loader
documentation that came with the above hardware
MicroVAX Information Processor, or EP or EE worksheets
communications wiring, labeling diagram
industrial
disk
Starting up and testing MicroVAX Information Processor
hardware requires:
checking module indicator lights
setting up the terminal and connecting it to the processor module
running power-up diagnostic self-tests
running system exerciser tests
formatting industrial disk
configuring
defaults
Chapter Objectives
Gather Your Equipment
Start Up and Test
MicroVAX Information
Processor Hardware