Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 162)

Installing and Removing a Module
Appendix A
A-6
2. Turn off the power supply.
Turn off the
power supply.
19792
3. Insert the module into the chassis.
Important: Make sure the module is firmly seated in the
chassis backplane before you secure the module in the chassis
using the thumbscrews.
a. Hold the module upright, with
its front panel facing toward you.
b. Align the module 's board on the module card guides and slides the
module into the chassis until:
Ć it seats firmly
Ć its faceplate is flush with the other modules
(The power supply is not flush with the other modules.)
19793