Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 167)

Installing and Removing a Module
Appendix A
A-11
Many of the connections you will make to a module are made to
connectors which you attach to another connector on the module.
To wire one of these connectors, follow the steps below:
1. Strip about 9 mm (1/4 to 3/8 in) insulation from the end of the wire.
3/8 in
(9 mm)
16801
2. Insert the wire into the connector as shown below.
Place tool here
This side plugs
into connector
on module
Insert wire here
OR
16856
Place tool here
Insert wire here
How to Wire a Connector