Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 46)

Chapter 4
Installing the Modules
4-8
To install the RM/KA module, use the worksheets as guides and complete
the following:
set the RM/KA module switches and jumpers
install the module in the chassis
install the battery (RM only)
set the KA module address
make connections to the module
set the keyswitch (RM only)
Set the RM/KA Module Switches and Jumpers
Set the RM/KA module switches and jumpers to configure:
switch bank 1 (communication parameters)
switch bank 2 (station address)
jumpers 9 and 10 (termination resistor)
jumpers 5-8 (channel 1 interface)
ATTENTION: If you perform operations on a module
improperly, you may cause an electrostatic discharge, which can
damage the module. Perform internal operations, such as setting
the jumpers, only in static-safe environment.
Channel 1 is factory set to RS-232. You do not have to remove the
memory board unless you are changing the channel 1 interface.
RM/KA Module