Metrohm tiamo 2.4 (process analysis) - Manual (Page 1055)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1039
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection Avantes Spectrometer
Default value Avantes Spectrometer
Instrument for reference channel
Shows the name of the instrument for the reference channel.
5.6.4.12.3 MEAS Ref - Measuring parameters
Tab: Method ▶ MEAS Ref ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Entry 25 characters
The parameters for the measuring procedure can be defined on this tab.
Start wavelength
Lower limit of the spectrum.
Input range 100.0 - 2000.0 nm
Default value 400.0 nm
End wavelength
Upper limit of the spectrum.
Input range 100.0 - 2000.0 nm
Default value 1000.0 nm